Reset to factory Default:
Reset to factory settings. Note this will erase all settings, including last firmware installed, upgrade keys and any type of configuration. Check Point recommends exporting settings before a reset to factory settings. You can reset factory settings in the following ways:
Press and hold the reset button on the back of the appliance for 10 seconds. The PWR/SEC LED will blink red once pressed. Release the button once it stops blinking.
You can do another type of factory-setting reset by following these steps:
Unplug the power cord.
Hold the reset button on the back of the appliance.
Plug in the power cord while holding the button, until the PWR/SEC LED blinks red steadily.
Press the reset button for 3 seconds.
Press the reset button again for 10 seconds until the PWR/SEC LED blinks red.
Reconfigure the appliance.
责任编辑:小草